8
RS
COMPONENT
SYSTEM
Fig. 4
Flush Mounting the Tweeter
Fig. 6
Surface Mounting the Tweeter
TWEETER MOUNTING
The tweeter can be mounted one of four ways: fl ush, angled, surface, and coaxial mounting. For fl ush
mounting applications, see
Fig. 4
. Choose a fl at location on the panel with space behind the panel to
allow room for the short mounting nut, motor structure, and tweeter. After checking the clearances, cut
a 1-3/4” (44mm) diameter mounting hole in the panel. Position the short mounting nut behind the panel.
Feed the wire through the optional fl ush ring, the hole in the panel, and the mounting nut. Mount the
tweeter by screwing the mounting nut onto the tweeter.
For angled mounting applications choose a fl at location on the panel with space behind the panel to allow
room for the long mounting nut, motor structure, tweeter post, and back angle ring. After checking the
clearances, cut a 1-3/4” (44mm) diameter mounting hole in the panel. Place the front angle ring in front
of the panel. Then place the wire and tweeter through the front angle ring and into the panel. Next, place
the wire through the back angle ring, place the back angle ring over the rear of the tweeter, and line-up
short
mounting nut
surface mount
cup
long
mounting nut
back angle ring
Fig. 5
Angle Mounting the Tweeter
front angle ring
rounded surface
inset surface
panel
panel
panel
fl ush ring
tweeter
tweeter
tweeter
2009 RS Multilingual f01.indd 8
2009 RS Multilingual f01.indd 8
11/21/2008 10:57:30 AM
11/21/2008 10:57:30 AM
