Page 5 of 10
Fig. 15
Fig. 16
Fig. 17
20.
Install the subwoofer amplifier into position by lining up the holes in the amp bracket with the two
holes for the bolts that retained the metal plate. Fig. 15
21.
Install the supplied bolt into the bottom hole and leave loose. Fig. 16
22.
Using a panel removal tool remove the four plastic retainers (three in front door opening and one in
rear door opening) securing the driver’s side sill plate and B pillar post cover. Fig. 17
23.
Gently pull the kick panel/sill plate toward the brake pedal to release the fasteners securing it.
24.
Connect the ten pin connector of the harness to the amplifier. Slide the red locking tab over to
prevent the connector from accidentally coming disconnected.
25.
Connect the green wire of the of the subwoofer harness to the green wire of the 4.1 amplifier
harness. Connect the brown wire of the subwoofer harness to the brown wire of the 4.1 amplifier
harness.
26.
Route the harness along the bottom of the front and rear door jam and toward the back seat.
Power Harness Installation
27.
Find the rubber grommet in the top driver’s side of the fire wall underneath the hood and remove it.
Fig. 18
28.
Using a razor knife make a small cut in the center of the grommet. Pass the power wires of both the
subwoofer and amplifier through the grommet and pull the grommet up to the point where the plastic
sheathing starts. Fig. 19
29.
Run the wires through the grommet hole in the fire wall and reinstall the grommet.
30.
Run the wires along the top of the fire wall toward the battery and secure with wire ties.