5
20. Connect the amplifier three-pin power connector to the three-pin power harness connector.
21. Connect the subwoofer harness black two pin power connector to the power harness two pin
connector.
22. Continue running the subwoofer harness down the driver’s side of the car to and under the
rear seatback. It is helpful to rotate the seatback down to allow clearance for the connecters.
Secure any excess harness to the factory harness under the driver’s side rear threshold
panel.
Amplifier Installation
23. Remove the three nuts securing the SIR module on the center hump in front of the console.
Fig. 9 Do NOT disconnect the wiring from the module.
24. Lift the module off the studs and set the amplifier/bracket assembly over the studs. Reinstall
the module over the studs and on top of the amplifier bracket and retighten the nuts. Fig. 10
25. Connect the amplifier harness to the amplifier.
Subwoofer Installation Hatchback
26. Remove the spare tire to retrieve the spare tire
safety strap equipped with the vehicle, and then
replace the spare tire. (Refer to owner’s manual,
beginning in section 10-67, for proper removal
and reinstallation of spare tire.) The safety strap
will be used to insure the sub- woofer enclosure
does not strike someone in the event of a
collision.
27. Place the supplied foam strip on the plastic
quarter panel cover in the position shown in Fig.
11 to prevent the enclosure from contacting the
panel.
28. Lay the poly bag that the subwoofer is packaged in on top of the carpet behind the driver’s
side seat- back. (The poly bag prevents the Velcro® from engaging the carpet prematurely.
Set the subwoofer on top of the poly bag and connect the subwoofer harness.
Fig. 11
Install
foam
strip
here
Fig. 9
Module
Fig. 10
Amplifier
installed
over
module
