3
Power Harness Routing
1. Disconnect negative battery cable from battery.
2. Using a razor knife make a cross shaped incision in the large rubber grommet from inside
the vehicle and feed the power harnesses from the engine compartment to the cabin. Using
a fish tape wire is recommended. Fig. 1
3.
Pull the power harnesses through the grommet until the sheathing touches the grommet.
4.
Remove the fuse box cover under the hood. Remove the fuses from the fuse holders on
both power harnesses and connect the power harnesses to the accessory lug. Torque to
9 +/- 1.5 Nm. Make sure that the wires exit on the side closest to the battery. Fig. 2
5. Install the white three pin power connector on the amplifier power harness. Close the
retainer. Fig. 3
Note: The terminals are keyed so that they
only install one way. If the terminal doesn
’
t
want to slide completely into the connector,
it may need to be rotated 180 degrees. It
does not matter which red wire goes in what
position of the connector.
6. Install the black two pin power connector on the
subwoofer power harness by first inserting the
terminal fully into the connector and then
depressing the blue retainer. Fig. 4
Note: Make sure the blue retainer in the
center of the connector is not depressed – it
should be flush with the front of the
connector. If the retainer is depressed, the
terminal will not fully seat in the connector
body. Make sure the terminal is installed
into position 1 on the connector body. There
should be a block-out plug installed in
position 2 in order to prevent the terminal
from being installed into the wrong position
on the connector.
Fig. 1
Cut
grommet
here
Fig. 2
Wire
should
exit
in
direction
of
arrow
Fig. 4
Insert
terminal
first
Then
depress
blue
retainer
Fig. 3
Insert terminals first.
Any wire can be in
any position.
Then
close
retainer
