4
16. Connect the amplifi er harness to the amplifi er.
17. Align the upper hole and speed clip of the amplifi er bracket with the hole that was used for the wire
retainer. The amplifi er bracket should be on the side closest to the brake pedal. Install the supplied M6 bolt
through the hole in the dash and into the speed clip on the bracket but leave loose. Fig. 9
18. Swing the bracket into place and line up the two holes in the front of the bracket with the two holes in
the dash used to secure the module and reinstall the screws you removed earlier. Fig. 9
Place your warranty card in the glove box for future use.
Power Wire Routing
19. Snap loose the driver’s side front threshold panel along the bottom of the door opening.
20. Snap loose the driver’s side kick panel by pulling straight back.
Fig. 7
Fig. 8
Remove
wire
retainer
from this
hole
Fig. 9
M6 Bolt
Installed
(Step 17)
Two factory
screws that
secure
module.
(Step 18)
