Kicker BX360.4, Руководство пользователя

Страница: 5 / 16

5 BX AMPLIFIERS
OPERATION
Input Level:
The RCA inputs on KICKER BX amplifiers are capable of receiving a Low-level signal from your
source unit. If the only output available from your source unit is a Hi-Level signal, you can use the HI LEVEL
INPUTS. Refer to the wiring section of this manual for additional instructions.
Input Gain Control:
The input gain control is not a volume control. It matches the output of the source unit to
the input level of the amplifier. Turn the source unit up to about 3/4 volume (if the source unit goes to 30, turn it
to 25). Next, slowly turn (clockwise) the gain on the amplifier up until you can hear audible distortion, then turn it
down a little.
Bass Boost Control:
The variable bass boost control on the top of the amplifier is designed to give you
increased output, 0–12dB, at 40 Hz. The setting for this control is subjective. If you turn it up, you must readjust
the input gain control to avoid clipping the amplifier.
Crossover Control:
The variable crossover on the top of the amplifier allows you to adjust the crossover
frequency from 50–200Hz. The setting for this control is subjective; 80Hz is a good place to start.
Crossover Switch:
Use the XOVER switch on the end panel of the amplifier to set the internal crossover to
OFF, LP or HP. When the switch is set to OFF, a full bandwidth signal will be amplified. Set the switch to HF if you
want the amplifier’s internal crossover to serve as a high-pass filter. Set the switch to LF if you want the amplifier’s
internal crossover to serve as a low-pass filter. Never change the crossover “OFF-LP-HP” switch setting with the
audio system on!
Input mode:
Set to 4CH if you are running two sets of inputs (AMP1 and AMP2) to the
amplifier. Set to 2CH if you want to drive all channels from a single stereo input (AMP1).
Remote Bass-BXRC (not included): When the crossover on your BX amplifier is set to LP pass, you have the
ability to control the output level of the amplifier remotely. To mount the BXRC remote bass level control, simply
screw the housing to the chosen location. Run the cable from the controller to the “Remote Bass” jack on the
amplifier chassis.
Note: When the crossover is set to LP, the BXRC only controls the AMP1 channel.