EOP2021-CS4
7/6/2021
REV-A.3
47KSMT25 Installation Guide
Page
4
of
8
TIGHTENING THE BALL AND SOCKET MOUNT
If the pod assembly will not remain stationary on the stud, the ball and socket clamp can
be tightened to prevent pod movement.
1.
Remove the nut and washer from the stud.
2.
Using a 2mm allen wrench, tighten the three bolts on the bottom of the pod to increase
clamping force on the ball and socket.
MOUNTING THE KSMT25 TWEETER POD
Choose a mounting surface that can be accessed from both side as a wing nut must be
installed on the mounting stud to retain the pod in its location.
1.
Drill a 9/16” hole in the desired mounting location.
