Vehicle Presets
Heater
When leaving the vehicle it is recommended to preset the accessory controls in preparation for the Next remote start. Settings for the blower motor(fan),front and rear (if
equipped),should not be left on HIGH. It is recommended to leave the settings on
LOW
or
MEDIUM
instead.
Windshield Wipers, Headlights
Certain vehicles require the windshield wipers and headlights circuits to become energized while running under remote start. When leaving the vehicle you must ensure that
the windshield wipers and headlights switches are OFF. Leaving the headlights switch ON on certain types of vehicles could cause them to remain ON even after remote
starter shutdown, resulting in a dead battery.
Leave Windshield Wipers off to avoid damage wipers/motor with remote start.
Changing the Remote Control Transmitter Battery
Remote transmitter should be provided with two 3-volt lithium battery (Model: CR-2025).
Please pay attention that with low battery LED in the remote might not work and the remote start distance might get shorter.
Batteries can be purchased at any electronic device stores.
Following the instructions below to change the remote control battery
1. You may use a coin to pry the remote control halves apart
2. Remove the old battery and replace with a new one
3. Be sure to observe the (+) sign when inserting the new battery.
4. Before assembling transmitter case, you should test the remote control.
