hook
part # 46.5172
assembled part
part # 46.5172
WireWorks
®
Tech Panel
3. There are three different
combinations of base tile hooks:
• Inline (full post)
• End-of-run (full post)
• Corner conditions that use half
post: 90˚ corner, 3-Way, 4-Way
and 180˚ inline
Inline
To install inline base tile hooks,
utilize two of part # 46.5172. Snap
pieces together at base of post and
rest on lip of glide housing with
hooks facing up.
Figure 3
.
End-of-run
To install end-of-run base tile
hooks, utilize one part # 46.5172
and one part # 46.5174.
Figure 4
.
End-of-run trim for Tech Panel has
a 2
1
⁄
2
" high notch.
Corner Conditions
90˚ corner conditions utilize
two part # 46.5172 and two
part # 46.5173.
Figure 5
. The
small piece without the hook is
mounted outboard, away from the
tile, keeping the trim support tab
pointed towards the universal trim.
Note:
A 3-way corner utilizes
three part # 46.5172 and three of
part # 46.5173.
A 4-way corner utilizes four of
each part.
A 180˚ inline uses two of each part.
Figure 3
Figure 4
Figure 5
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and injury.
tile hook
end-of-run trim
part # 46.5172
part # 46.5174
assembled part
notch in trim is 2
1
/
2
"
high to accomodate base
tile hook assembly
universal trim
part # 46.5173
trim support tab
part # 46.5172
part # 46.5172
part # 46.5173
assembled parts
