2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Tattoo
™
Storage - Low Cupboard
Assembly Instructions
Figure 2
leg post
(glide)
stem-mount
glide
stem-mount
glide
storage unit
(low cupboard
shown)
stem-mount
glide
leg post
(glide)
Detail B
storage unit
(low cupboard
shown)
Glide Installation
1. Thread the stem of each glide into
the threaded insert at the underside
of each leg post. Twist the glides in
clock-wise, fully to the bottom of
the leg post. This will allow level
adjustment of the low cupboard if
required when placed in its final
location (Figure 2 & Detail B).
2. Once all glides have been installed
to the underside of the low cupboard
leg posts, carefully turn the cupboard
to the upright position.
Caution:
The assistance of a second person is
required to turn low cupboard units
to the upright position.
3. Place the low cupboard in its final
location. To raise a leg of the unit for
leveling, rotate a glide out as needed.
To lower a low cupboard leg after it
has been raised, turn the glide back
into the leg as needed. Only adjust
the glides as needed to make the low
cupboard level.
4. If a padded topper is to be installed
on the low cupboard, go now
to “Padded Topper Installation”
instructions on page 6. If a
raised-worktop is to be installed
on the low cupboard, go now to
“Low Cupboard, Raised-Worktop
Installation” instructions on the next
page.
