3
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
Aristotle
®
Casegoods - Two-Piece Conference Table
Assembly Instructions
table base
shoulder
pin screw
Figure 4
#8 x 1”
RWH screw
tabletop
tabletop
splice
plate
cam
Detail E
shoulder
pin screw
cam
Detail F
#8 x 1”
RWH screw
angle
bracket
cam
4. With table halves joined together
tightly and precisely, align the four
splice plates over the pre-drilled
holes at each side of the joint
fasteners as illustrated, then tightly
secure each splice plate using eight
#8 x 1” RWH screws, four per splice
plate side as illustrated (Figure 4).
5. At each base installation location,
insert and twist four shoulder pin
screws into the 5mm diameter
pre-drilled holes in the underside
of the joined tabletops as illustrated
(Figure 4).
6. Carefully turn each table base upside
down onto the tabletop underside
one at a time, inserting the shoulder
pin screws of the worksurface into
the corresponding camlock holes
at the top edge of the table bases.
Open the table base door and locate
the camlocks inside the base, then
twist each camlock clockwise to the
2 O’Clock position to lock (Figure 4
& Detail G).
7. Once table bases are camlocked
to the joined tabletops, identify the
angle brackets inside the base, then
twist in and tighten two #8 x 1”
RWH screws per bracket, to further
secure the base to the underside
of the worksurface as illustrated.
After all 8 screws per base are tight,
close the table base door (Figure 4
& Detail F).
8. With the assistance of two or
more people, carefully turn the
table upright and level the table as
required.
Detail G
Step 1
Step 2
Rotate Camlock to
the 2 O’Clock position
to
lock.
FULLY
2 O
’Cloc
k
shoulder
pin screw
