2
Assemble units as described herein only. To do otherwise
may result in instability. All screws, nuts and bolts must be
tightened securely and must be checked periodically after
assembly. Failure to assemble properly, or to secure parts
may result in assembly failure and personal injury.
tabletop
tabletop
Figure 2
Two-Piece Conference Table
Assembly
1. Carefully unpack all parts and
identify the hardware required below
from the “Hardware Pack” diagram.
Set tabletops upside down on a soft
protective surface.
Note:
One hardware pack is
supplied per table base, to secure
each base to the tabletop underside.
Another hardware pack is supplied
when two table surfaces must be
joined together.
2. To join two-piece table halves
together, first align the surfaces to
be joined so the holes for the joint
fasteners face each other. Then slide
both worksurface halves together
and align edges perfectly to each
other (Figure 2).
3. Locate the joint fasteners hardware
pack. If not pre-assembled, loosely
twist joint fastener connector plates
onto each toggle bolt, then set
the joint fastener assembly into
the bored holes and slots in the
worksurfaces as illustrated. Using
a wrench, tighten the toggle bolt to
bring worksurface halves together,
taking great care to make sure
edges and table surfaces are aligned
perfectly (Figure 3 & Detail D).
Aristotle
®
Casegoods - Two-Piece Conference Table
Assembly Instructions
tabletop
tabletop
Figure 3
joint fastener
with connector
plates
connector
plate
Detail D
joint
fastener
7HP39 - Hardware Pack
shoulder pin
screw
#8 x 1” RWH
screw
4
8
(one per base)
7HP18 - Hardware Pack
joint fastener
splice plate
2
4
(two-piece conference table)
#8 x 1” RWH
screw
32
