Connecting the speaker wire to the speaker output should be done as shown on
the pictures below:
Step 1.1: Unscrew the connector enough for the spades to slide under the black
block.
Step 1.2: Slide the spades beneath the connector block over the pins.
Step 1.3: Screw back the top of the connector.
STEP 2
The cable from your preamplifier can be connected to the input using an XLR
connector or, if you have chosen the RCA version, an RCA cable.
STEP 3
Attach a power cord to the power inlet. BE CAREFUL to connect
your power cord to a 115V or 230V power source depending on the
configuration of the amplifier! If you are not sure about the voltage
to which your amplifier is configured please contact your dealer.
DO NOT switch on the power until all wiring is connected correctly!
We advice you to use only Kharma power cords.
The amplifier is supplied with a gold plated copper isolator. For the best sound
quality it is preferred to put this isolator on the amplifier. However some power
cords are too big and make it impossible to use the isolator.
After the power cord is connected the amplifier will set into default operating
mode, there will be relais switching audible. This will take about one second.
The amplifier is now in off position. It is advised to turn off the amplifiers only
when not used for a long time e.g. during holidays.
