KGS Corporation BL-1000, Инструкция по эксплуатации

Страница: 10 / 38

Instruction Manual
10
KGS Corporation
1.6 How to set a braille tape
A braille tape is not set inside the body of BL-1000 before shipment. Please set
an attached braille tape for exclusive use for print by the following procedures.
Procedure for setting a tape
1.
Connect BL-1000 to AC adaptor.
It shortly sounds like a mechanical
movement to send a braille tape to the exit,
and slightly long beep sounds at three times.
This means to be out of a braille tape.
2.
Open a cover for a braille tape, set a
whole braille tape with a paper case
vertically in the center between partitions in
the body.
Set a paper case which side is higher than
other one, so as to be in the left side in the
tape holder place. (left side is close to the
tape entrance)
3.
Remove a seal which fixes an edge of a
braille tape on a roll.
Insert an edge of a braille tape into the
entrance of printing section, and insert it by the
place to meet an inside roller of printing
section.
①
②