KGK CCS3000L, Инструкция по эксплуатации, Страница: 19 / 62

19
Main unit (rear side and left side)
No. Name Description
1 Head cable
Cable for connecting the main unit to the printhead. The length is 3.5 m. This cable
cannot be disconnected from the printhead. (Minimum bending radius: 35 mm)
2 Air filter
Prevents foreign bodies such as dust from entering the inside. Periodically
perform maintenance.
3 Inlet
Air intake for ventilation and cooling of the inside of the main unit.
Avoid plugging up the inlet.
4 Printhead fixing unit Unit for fixing the printhead at the time of transportation
5 Cable holder This is not a handle for transportation. Use the handles on the sides of the main unit.
6 Power cable Power cable. This cable cannot be disconnected from the main unit.
7
Photocell sensor
connector
To use a photocell sensor, connect it to this connector.
8 RS-232C connector To use a RS-232C cable, connect it to this connector.
9 I/O connector
To use an external device, connect it to this connector. When connecting the
PLC, connect according to the instruction manual for PLC.
10 LAN connector To use a LAN communication cable, connect it to this connector.
11 Purge pump connector To use an air purge pump, connect it to this connector.
12 UPS connector To use a UPS, connect it to this connector.
13 Encoder connector To use an encoder, connect it to this connector.
14 Signal lamp connector To use a signal lamp, connect it to this connector.
15 Outlet Discharges heat from the inside of the main unit.
16 Frame ground Connect a ground terminal to this part.
17 Condensate Tank Unit Stores the waste liquid.
18
Air ventilation
(for Japanese use) Connect this part to a dry air source for printhead purging.
Set the pressure setting to 0.1Mpa.
2
3
6
5
15
16
17
1
18
7 8
14 13 11
19
12
10
9
4