©2021 Copyright Kappers Fabricating, Inc. All rights reserved
Page 3
POSITION 2
POSITION 1
1. Rear mounted contactors will use the contactor mount
bracket (2). Attach the contactor to the bracket using
the 1/4” hex bolts (6), washers and 1/4” nylock nut (7).
Fasten the contactor assembly to the mount with the
supplied 1/4” Carriage Bolt (16) and 1/4” Nylock Nut
(7).
1. Top mounted contactors will use the supplied contactor
mount bracket (2), the 1/4” hex bolts (6), washers and
1/4” nylock nut (7). You will need to mount the winch
to be able to attach the bracket (2). The bracket is held
to the mount using two of the four winch mounting
bolts.
2
6
7
Winch Bolts
16
2
7
2. Slide the winch into the mount per orientation shown
in Figure 1. Mount your winch to the Mount using
the proper hardware supplied with your winch. Don’t
forget to route your winch cable through your fairlead
and attach your hook. If your winch leads come close
to hitting something, a lot of winches can also have
the leads rotated if needed (check with your winch
provider).
3. Mount the entire winch assembly (winch, mount,
contactor, and fairlead) into location and assemble
using the included 8MM hardware. Shown in image
below.
4. Wire the winch up per the instructions that came with
your winch.
Note: Under the front rack there is a orange and white
accessory wire that you can tap your switch into.
2. Slide the winch into the mount per orientation shown
in Figure 1. Mount your winch to the Mount using
the proper hardware supplied with your winch. Don’t
forget to route your winch cable through your fairlead
and attach your hook. If your winch leads come close
to hitting something, a lot of winches can also have
the leads rotated if needed (check with your winch
provider).
Note: With a (Rear) mounted contactor you will need
to pre-wire everything to the contactor before attaching
the assembly to the machine. Run the battery, and switch
wires down to the front of the machine where the winch
is placed per the wiring instructions provided with the
winch.
3. Attach all the wires to the contactor per the wiring
instructions included with your winch.
4. Mount the entire winch assembly (winch, mount,
contactor, and fairlead) into location and assemble
using the included 8MM hardware. Shown in image
below.
Note: Under the front rack there is a orange and white
accessory wire that you can tap your switch into.
