How to Assemble
CAUTION:
Do not insert the plug into the power point before assembly is complete.
(May cause electric shock or injury)
Do not press height adjustment button while fan and fan guard are
detached.
(The motor section (slide pipe) may jump out of stand, causing injury)
1. Fix the stand onto the base
Remove the motor shaft cover.
Check the stand direction by the
indication of front and back of
the base and stand, insert the front
protusions of stand into the concave
-es of the base, then push the
whole stand part down onto the
base until it is fitted in firmly.
Placing the motor shaft upward,
then fix the stand and base by
turning the base fixing ring
provided clockwise.
Attention:
Base fixing ring is temporarily attached on bottom of stand. Unscrew it
When you assemble the fan.
Do not forcibly push the stand down onto the base. May cause damage.
Do not put the stand onto the base in wrong direction. May cause damage.
Do not press the height adjust button while assembling. May cause injury,
damage to the product or machine failure.
2. Fix Rear Guard and Fan Blade
Couple protrusions (three) on the motor section to concaves (three) on the
rear guard.
Fix them firmly by turning the guard fixing ring toward [fasten].
Couple the pin on the motor shaft and the concave on the fan blade and insert
the fan part into the motor part. Then pressing the fan part towards the motor
part and turn the fan blade cap toward [fasten] to fix them firmly.
Attention:
If the fan blade cap is not fastened firmly
enough, fan blade may come off, causing
injury.
Be careful not to be injured by motor shaft
or pin when assembling or disassembling.
3. Fix Front Guard
Use tool to lock the screw and nut of the guard, turn counter clockwise fixation the front
guard.
How to Take off Front Guard
Use tool to unlock the screw and nut of the guard, turn counter clockwise
remove the front guard.
After cleaning, turn clockwise to assemble the front
guard, and use tool to lock the screw of the guard.
P5-14606
