Q: The Dialer’s input has been activated correctly and the image “Trig 1” or “Trig 2” appears on the LCD display
to indicate this. However, it is not then dialing out and an error message is appearing on the LCD display.
A: Check the following carefully.
i) Have you recorded at least 1 message and programmed at least 1 telephone number to the Dialer ?
ii) Have you deleted a telephone number by mistake ? Go to Programming Section 3. To check whether the
1
st
telephone number you think you have programmed in
is in the Dialer’s memory correctly, Press
1234 (code) > Program > 3 > Enter >1 > Enter. You should now see that telephone number. Press
Enter again to Exit programming. If you don’t see a telephone number there, enter the number again
and press Enter to exit. Do NOT press ESC to exit as this will delete that number.
iii) Have you de-selected a number to be dialed out in sequence for that trigger by mistake ? Go to
Programming Section 6. To check the numbers that are being dialed in sequence for Trigger 1, press
1234 (code) > Program > 6 > Enter >1. You should now see various numbers between 1 and 0
illuminated. If a number is unlit, it means it is not being dialed for Trigger 1. Toggle numbers on/off by
pressing that number on the keypad. A number must be lit in Section 6 if it is being dialed for that
trigger.
Q: I can’t cancel the remote dial-out remotely by pressing, on the remote telephone hand-set either * (cancel dial
out and alarm sound if programmed) or #’ (cancel dial out only, alarm sound will continue until time out)
A: Have you waited until the message has ended ? You cannot cancel until it has been played to you at least
once.
