How to set Arm Delay times: (Default set at 0 seconds, instant)
– Section 5
Set arm delay time between 0, 30 and 60 and 90 seconds: This is the delay between the dialer being armed or
primed and the time the triggers are active or ON. Default setting is 0 seconds, or no arm delay. Note that if an
arm delay time is programmed, then the ON symbol on the LCD display will flash throughout the programmed
time delay period.
Quick Guide Press 1 2 3 4 > PROGRAM > 5 > ENTER > n > ENTER
1. Key in the four digit user Password code (factory default 1234).
2. Press PROGRAM > 4 > ENTER > N > ENTER.
(Note: N=0, instant; N=3, 30 sec; N=6, 60 sec; N=9, 90 sec)
How to set an Arm Delay Sound: (Default setting without sound)
– Section 7
Quick guide: Press 1 2 3 4 > PROGRAM > 7 > ENTER > 0 > ENTER
1. Key in the four digit user Password code (factory default 1234).
2. Press PROGRAM > 7 > ENTER > N > ENTER.
(Notice" 0= without sound; 1 = with sound.)
How to turn the Dialer On/Off locally or remotely
How to Turn the Auto Dialer ON : (Default On. That means the Dialer will always be active or ON when
power is first applied or re-applied to it. Turn Off to programme and then turn back On and leave On)
Quick guide: Press 1 2 3 4 > ENTER
1. Check that the voice message and at least one phone number has been programmed into the Dialer.
2. Press 1 2 3 4 ENTER. The Dialer
will show “ON" on the display.
3. The triggers will become active after the delay time you have set has expired. (Default set at 0 seconds,
instant)
How to Turn Dialer OFF or to stop it dialing out after it has been triggered :
Quick guide: Press 1 2 3 4 > ESC
To turn the Auto Dialer OFF or to stop it from dialling out after either the tamper switch (if connected and
active) or a trigger input has been activated, key in the <Password> following by ESC. The Auto Dialer will
revert to the "OFF" mode and must be re-set to the "ON" mode as above.
How to stop the dialer dialing the telephone numbers in sequence :
Quick guide: When the phone is answered, press <#> or <*> on the telephone keypad to stop the dialing
sequence.
When the Auto Dialer starts dialing, it will dial the first telephone number and repeat the pre-recorded voice
message five times. If there is no response from the phone, then it will hang up and dial the next number until all
the programmed numbers for that trigger are dialed. It will repeat this dial sequence three times and display "NO
ANSWER" if there is no response from any of the phone numbers. To stop this dial sequence, press the <*> key
on the telephone keypad that is receiving the call. At that time, the Auto Dialer will stop its dialing sequence and
the alarm (if programmed) will stop. If the local alarm has been programmed as active, then pressing the <#> key
will stop the dialing sequence, but the alarm will continue to sound until timed out. In both cases, the Dialer will
remain ON, waiting for any further Trigger.
