Keystoker – Schuylkill Haven, PA 17972
Koker, Koker Lite & Econo 90 Stoker Coal Stoves
© June 2019 REV 4
- 6 -
Assembly
1.
Plumb hopper end of stove with level. Hopper end of stove must be vertical.
2.
On bottom vent models, mount timer on side or rear of coal hopper.
3.
Mount hopper in place and fasten securely. Carefully, reach down into bottom
of inside hopper and bend flange of hopper into throat of stoker unit.
4.
Ensure all power for this unit is turned off. Locate thermostat in an area where
heat from stove can be freely reached. Mount plastic wall plate of thermostat.
Connect thermostat wires to screws on lower portion of wall plate. According to
instructions, run terminal Red & White thermostat wires to Relay on stove and
connect wires to terminals marked T.T. (note: color coding of thermostat wires is
unimportant.) Be sure to snap thermostat securely onto wall plate.
5.
Install stove pipe from stove to chimney and secure with screws. On top vent
models, place the non crimped end of pipe of barometric damper down onto
the 6” exhaust outlet on stove. Swinging door on barometric damper may face
any direction; however, the hinges must be horizontal.
a.
High chimneys or high winds could cause stove to operate inefficiently
and could possibly damage stove mechanism. It is therefore necessary
that you install the barometric damper that is supplied with your stove. All
top vent stoves are required to use an automatic damper.
6.
Ensure all terminals are properly connected. Plug power cord into 110 volt
grounded wall outlet. Combustion blower should be running. Turn the thermostat
up to make the feed motor operate and you are now ready to start a fire.
Fuel Type
1.
Burn rice Anthracite coal only.
Danger risk of fire or explosion. Do not burn garbage, gasoline, drain oil, or other
flammable liquids. Do not use chemicals or fluids to start fire.
