Operation Manual KSK-3200 RF
E&OE
- 12 -
2.4 New-synchronisation of the radio channel
The
KSK-3200 RF
is equipped with the newest radio technology allowing in the easiest manner to make a
new-synchronisation.
•
In contrast to conventional or older wireless keyboards on the
market here is to press the PAIRING key on the back side only 1
time, whereby the new synchronisation signal is transmitted to the
USB
receiver
. Place the keyboard for pairing in a short distance of
approx. 30 cm from the USB receiver.
•
A successful synchronisation is signalised by 3 times flashing
of the PAIRING-LED (left LED on front side of the keyboard).
The keyboard is now re-synchronised.
•
Check now the functionality of the keyboard like described
under point 2.3.
Advise:
One further benefit of this newest radio technology is the provision of a large number of possible,
independent from each other „radio channels“ (16 channels *2
16
Bit = 1.048.576 possible contacts or
even IDs) to ensure a trouble-free and secured operation of several wireless keyboards in one room
respectively in a transmitting/receiving radius of approx. 10 m.
In implausible case the keyboard does not work even after new-synchronisation, you have the following
options to solve this problem:
•
Repeat the procedure as described above. In very rare cases it is necessary to repeat this routine several
times until the right „radio channel“ is found.
•
In case your USB receiver is attached to an USB hub, you should install it directly on the USB connector
of your notebook or desktop.
•
During the procedure of synchronisation the keyboard should be located close to the USB receiver to
make sure, that the immediate environment has no influence on the radio transmission (for instance
reduction/interferences due to metal cases, other sources of interferences etc.).
•
Ensure that you use only batteries with full loading capacity. In case of doubt change the old batteries
before next synchronisation against new ones as a precaution.
