U1190A Series Handheld Clamp Meter
Install the Batteries
2
U1190A Series Quick Start Guide
Install the Batteries
Your clamp meter is powered by two
1.5 V AAA alkaline batteries (included
with the shipment).
1
Turn the clamp meter OFF and remove
the test leads from the terminals.
2
Loosen the screw on the battery cover
with a suitable Phillips screwdriver.
3
Remove the battery cover and observe
the polarity markings.
4
Insert the batteries and replace the
battery cover and screw.
Power ON the Clamp Meter
To power ON your clamp meter,
turn the rotary switch from the
OFF position to any other posi-
tion.
Using the Wire Separator and Hook
Mesh of
wires or
cables
1
Open the clamp jaw
slightly to reveal the
wire separator tip.
2
Separate the
desired wire or
cable by hooking it
in the clamp jaw.
3
Secure the
wire or cable
and read the
measurement.