Keysight TS-5020, Руководство по подготовке места и установке

Страница: 31 / 45

Site Preparation and Power Requirements
3
TS-5020 Automotive Electronics Functional Test System Site Preparation and Installation Guide 3-7
Minimum Power Requirements
The following lists the minimum power requirements for the
TS-5020 Automotive Electronics Functional Test System:
1
AC mains power must be supplied to the system’s power
distribution unit (PDU), Keysight E1135C.
2
AC voltage and current ratings: see
Table 3-2
3
Power cord for all systems and options to be supplied by
customer.
Power Recommendations
• Provide a separate AC mains for the system due to the
current requirements of the system.
• Use copper wire for the system drop between the AC source
and system.
• For Keysight E1135C PDU, a jumper wire may need to be
installed for some options. This PDU has a mains disconnect
switch that serves as master power for the entire rack.
• The power service may have a mains disconnect installed
adjacent to the system to quickly remove power in case of
emergency (see “Mains Disconnect Requirements” for more
information).
C A U T I O N
Power cord must be wired by an electrician.
Table 3-2 AC Power Requirements
AC Frequency AC Voltage Range AC Current (max) No. of Phase PDU Supported
47Hz to 63Hz 200 - 240 VAC 5 amps Single Phase E1135C
200 - 240 VAC 4 amps Three Phase E1135C
100 - 120 VAC 10 amps Single Phase E1135C