Keysight N5264A Service Guide 7-11
Repair and Replacement Procedures
Removing and Replacing the A1–A3 and Other Front Panel Subassemblies
To replace the touch screen, note the orientation of the rubber boot on the
old touch screen and then remove it and install it on the new one in the
same orientation.
Figure 7-4
A3 Display Assembly and Touch Screen Removal-1
4.
The display cable (item
⑥
) can be removed by removing the three screws
(item
⑦
) that attach it to the LCD display hold down bracket (item
⑧
).
5.
The LCD display can be removed by disconnecting the LCD cable from the
inverter board and then removing the four screws (item
⑨
) that attach it to
the LCD display hold down bracket (item
⑧
). Note the location of the four
spacers (item
⑩
) before separating the LCD display from the hold down
bracket.