Keysight N5247-60116, Установочная инструкция

Страница: 38 / 46

38 Installation Note N5247-90116
Description of the Upgrade
Installation Procedure for the Upgrade
-
Step 20. Reinstall the Outer Cover
Refer to Figure 18 for this step of the procedure.
1. Slide the outer cover over the analyzer frame.
2. Install the four rear panel feet (item
⑤
) by installing the center screws
(item
⑥
) with a T-20 TORX driver.
3. Install the four bottom feet (item
④
) onto the bottom of the outer cover
then install the foot locks (item
③
).
4. Install the strap handles (item
①
) by tightening the screws (item
➁
) on
both ends of each strap handle with a T-20 TORX driver.
Figure 18 Outer Cover Re-installation
This procedure is best performed with the analyzer resting on its front
handles in the vertical position. Do not place the analyzer on its front panel
without the handles. This will damage the front panel assemblies.