Keysight 86205A, Руководство по эксплуатации и обслуживанию

Страница: 21 / 45

Operation 2
Keysight 86205A Operating and Service Manual 21
Vector impedance measurement configuration
This configuration provides a low-cost custom test system when full 2-port measurements are not
needed.
To set up the measurement
1 Connect the equipment as shown in Figure 2-4 .
Figure 2-4 Vector impedance measurement setup
2 Choose the following parameters on the analyzer:
PRESET
MEAS, A/R
(or B/R if you connected the analyzer input signal to the B input port)
MENU, POWER then enter the power value and press x1
NUMBER OF POINTS then enter the desired number
START then enter the start frequency and press x1
STOP then enter the stop frequency and press x1
3 Make a measurement calibration by pressing one of the following key sequences:
CAL
Cal Kit, N 50
W
Return, Calibrate menu
RESPONSE
connect either an open or short calibration device to the reference plane and press
the corresponding OPEN (F) or SHORT (F) key.
NOTE
You may connect the analyzer input signal to either the A or B input port. Use an A/R or B/R ratio
measurement to improve the source match.
KEYSIGHT 8753C
NETWORK ANALYZER
KEYSIGHT 86205A
DIRECTIONAL BRIDGE
KEYSIGHT 86205A
DIRECTIONAL BRIDGE