Keysight Technologies N4000A SNS Series, Руководство по эксплуатации и обслуживанию

Страница: 48 / 81

4 Operating Guide
48 Keysight N4000/1/2A Operating and Service Manual
Disassemble the SNS series smart noise source by performing the following steps.
1 At the rear of the noise source, insert the blade of a screwdriver between the
plastic shells (see Figure 4-14 on page 47 ). To prevent damage to the shells,
use a screwdriver blade as wide as the slot between the two shells.
2 Pry alternately at both sides of the connector until the plastic shells are apart.
Remove the shells and the magnetic shields.
Reassembly procedure
1 Replace the magnetic shields and plastic shells as shown in Figure 4-12 on
page 44 .
2 Snap the plastic shells together.
Returning the SNS series smart noise source for calibration
When returning the N4000/1/2A to Keysight Technologies for calibration, send it
to your nearest Keysight Sales and Service Office. Refer to “Sales and Technical
Support” on page 6 of this manual.