Keysight Technologies M8190A, Руководство по началу работы

Страница: 27 / 34

Introduction 2
M8190A Getting Started Guide 27
2.7 Basic Problems
Query
The M8190A firmware does not come up.
Solution
You should power cycle the chassis and reboot the host system.
The following is the power-up sequence:
1. Power up the chassis first. Use the ON/STANDBY button on the front panel of
the chassis.
2. Wait until the chassis ESM Status LED becomes steady green.
3. Wait another 60 seconds for the chassis to finish booting up.
4. Power up the remote host.
If you are using the AXIe Embedded Controller Module as the host computer, then you
need not perform the host PC power up steps because the Embedded Controller startup is
managed internally and the controller automatically starts after the chassis power is
stable.
Query
The instrument is not listed in Keysight Connection Expert's Instruments View.
Solution
1. See if the instrument is listed in Keysight Connection Expert's Instruments
View. Many LAN instruments are auto-discovered and you do not need to add
them. When the system starts for the first time you will see the PXI instrument
entry in the Keysight Connection Expert's Instruments View:
2. If the instrument is not listed, click the Rescan button in the Instruments View
and wait for the "Rescan complete" message to appear in the message area at
the bottom of the window. This may cause the instrument to be added to the
list.
3. If the instrument is still not listed, follow the instructions below to add the
instrument manually.
a. Select Manual Configuration.
b. Select Add New Instruments/Interfaces.