Keysight Technologies E4981A, Руководство по программированию

Страница: 238 / 383

236 Chapter 10
Command Reference
E4981A SCPI Commands
[:SENSe]:CORRection:DATA
Syntax
[:SENSe]:CORRection:DATA {STAN1|STAN2|STAN3},<numeric 1>,<numeric 2>
[:SENSe]:CORRection:DATA? {STAN1|STAN2|STAN3}
Description Sets the correction data for OPEN/SHORT/LOAD correction.
These correction data are measured for the measurement frequency used in executing the
command (set with the :SOURce:FREQuency[:CW] command).
When using the multi-correction function (set to ON with the
[:SENSe]:CORRection:MULTiple[:STATe] command), this is set as the correction data for
the selected channel when executing the command (selected with the
[:SENSe]:CORRection:MULTiple:CHANnel command).
To activate the set correction data, use the [:SENSe]:CORRection:OPEN[:STATe] ,
[:SENSe]:CORRection:SHORt[:STATe] , and [:SENSe]:CORRection:LOAD[:STATe]
commands to turn on the OPEN/SHORT/LOAD correction function.
The transfer format of data read out with this command conforms to the setup of the
:FORMat[:DATA] command.
Parameters
• When specifying STAN1 as parameter 1:
• When specifying STAN2 as parameter 1:
Parameter 1: {STAN1|STAN2|STAN3}
STAN1 Sets or reads out the data for OPEN correction.
STAN2 Sets or reads out the data for SHORT correction.
STAN3 Sets or reads out the data for LOAD correction.
Parameter 2: <numeric 1> Parameter 3: <numeric 2>
Description
Value of the primary parameter
*1
. Value of the secondary parameter
*1
.
Range -99.9999E9 to 99.9999E9 -99.9999E9 to 99.9999E9
Initial value 0 0
Unit Depends on the type of parameter. Depends on the type of parameter.
*1.Use the [:SENSe]:CORRection:CKIT:STAN1:FORMat command to specify the type
of parameter.
Parameter 2: <numeric 1> Parameter 3: <numeric 2>
Description
Value of the primary parameter
*1
. Value of the secondary parameter
*1
.
Range -99.9999E9 to 99.9999E9 -99.9999E9 to 99.9999E9
Initial value 0 0
Unit Depends on the type of parameter. Depends on the type of parameter.
*1.Use the [:SENSe]:CORRection:CKIT:STAN2:FORMat command to specify the type
of parameter.