Page 1
»
See the hex value/binary number conversion table to generate the proper number to enter
for this value.(pg. 4)
»
The status display through RS-232 has been updated to reflect the changes.
»
Output:
»
01 : Video= 01, Audio= 01, IR= 01 : Active : Mute Interval= 00
Balun= VAC : V= 50 B= 20 L= 12 M= 12 T= 12 LP= 00
»
02 : Video= 02, Audio= 02, IR= 02 : Active : Mute Interval= 00
Balun= VAC : V= 50 B= 20 L= 12 M= 12 T= 12 LP= 00
Pin out for using KD-CVARX Baluns with KD-MSWCAT8X8 / 4X4
Please note that to utilize the KD-CVARX Baluns you will need to terminate your CAT5 cabling
using the following pin out:
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
KD-MSWCAT8X8 / 4X4
KD-CVARX
Analog Audio
Balanced Audio
Left
Left
Right
Gnd
Gnd Left + Right+
Gnd
Gnd
+ –
+ –
Tip
Ring
Sleeve
R
L
Digital Audio
Gnd
PCM
Gnd
+
+
Gnd
R-
L-
Gnd
R+
L+
Right
IR routing through KD-MSWCAT8X8 / 4X4:
In order to send IR signals through the KD-MSWCAT8X8/4X4, you will need to follow the
configuration described below.
½
To input IR signals, you will need to convert your powered IR distributions
output to an RCA type connector. Typically you can use a mono 3.5mm jack
to RCA adapter (as shown).
½
Using a standard RCA male to male cable, connect this RCA to the unused ‘H’ or Horizontal
Sync input going into the switch. The supplied breakout cable is used for Component signals
and has 3 RCA connections. You will need a 5 RCA to VGA (Part number KD-VACBL not
included) breakout connector for both Switch and Balun. (Total of 2 per signal, see complete
parts list below).
½
NOTE: When using the KD-CVARX Baluns, you will need to supply a female
to female HD15 gender changer to connect the Balun to the breakout cable
(KD-VACBL) this changer is not needed for the KD-VACRX Baluns.
½
At the Balun side, plug an RCA to 3.5mm female mono jack adapter into the
unused ‘H’ or Horizontal output coming off the HD15 to 5 RCA breakout cable from the Balun.
You may plug your emitter directly into this adapter which can then be placed onto your display
or any other device you wish to control. You may repeat this for each IR signal you wish to route
through the KD-MSWCAT8X8/4X4.
