Page 2
© 2010 Key Digital, Inc. All rights reserved.
The following new features have been added to both
the KD-MSWCAT8x8 and KD-MSWCAT4x4 products:
Key Features
»
Allows the use of either KD-VACRX or KD-CVARX receive Baluns
»
KD-CVARX can be used with a Digital or Analog Audio Input (Analog Output only)
»
Can now route IR signals when in Component mode via unused “H” (Horizontal sync)
signal path
Key Benefits
»
Can mix both KD-VACRX and KD-CVARX Baluns on single unit
»
Control display or other local (room) components by sending IR through KD-VACRX and
KD-CVARX Baluns
»
Allows use of KD-CVARX Baluns when Digital Audio and RS232 Output isn’t required
Additional Key Features
»
Front panel LED input/output assignment confirmation
»
Easily controlled via IR Remote (included) with discrete codes, Serial IR, and RS-232
»
Slim 1U Rack chassis for space conservation
RS232 Commands:
The following new RS232 commands have been added to provide control for the new features:
½
‘SPCVTx’
- Video Type command: where x = 0 or 1 (0 = Component, 1 = RGBHV)
»
Note: default is component.
»
This command determines whether unit will switch Component or RGBHV signals.
»
Example:
To switch the unit from Component to RGBHV mode, enter the command;
‘SPCVT1’
»
(Please note that a system reboot is required after a ‘Video Type’ switch for the settings to
take effect)
½
‘SPOxxSRyy’
– IR Switching command: where xx = Output number, yy = Input number.
»
This command directs the IR path from your chosen input to your chosen output
independent
of your A/V routing.
»
Example:
to direct the IR path from input 4 to output 2, issue the command:
‘SPO02SR04’
»
NOTE: for expansion configurations, total number of inputs will be limited to 8
(or 4 for KD-MSWCAT4x4
»
The default assignments for IR routing are Input 1 to Output 1, Input 2 to Output 2 etc.
½
‘SP C C5T hh’
- CAT5 Output Type Mask: where hh = hex value for selecting which outputs will
have KD-VACRX Balun and which will have KD-CVARX Baluns (0-VAC, 1-CVA) ‘0’ is the default
setting
»
This command tells the unit which type of Balun is connected to each output number. A
selected output will choose the KD-CVARX Balun; an unselected output chooses the KD-
VACRX Balun (default).
