Key Digital KD-IP120POERX, Руководство пользователя, Страница: 17 / 88

17 | P a g e
IGMP Setup Guide: Cisco SF500-48
1080p Systems (KD-IP1080, KD-IP120)
Note: Compatible with KD-IP1080, KD-IP120 Enterprise AV Systems Only
1. Before Cisco network switch is configured Key Digital KD-IP120/KD-IP1080 HDMI switch set must be
connected to all HDMI sources/displays/network switches, and configured using Key Digital KD-IP120 Key
Digital Management Software latest version.
2. Power-up all the system components. Using Key Digital KD-IP120 Key Digital Management Software, switch
All Outputs -> Through at switching page.
3. IMPORTANT : Disconnect all the DHCP devices like routers, servers from the Cisco network switch.
4. Locate a pinhole “RESET” button at the front panel left bottom corner of your Cisco network switch. Using a
paper clip press and hold a reset button for more than 10 seconds and then release. Wait while the device
is restarted and ready to use (about 5min).
5. IMPORTANT : Make sure the green “SYSTEM”LED next to the pinhole “RESET” button is flashing.
6. IMPORTANT : At this point all the displays should be displaying distorted randomly flashing video images.
7. Connect your PC to the Cisco network switch directly using a network cable.
8. If you have not done yet, configure your PC’s IP address to the same range as the switch (default
192.168. 1 .xxx ).
9. Enter the switch’s IP address in your browser and press ENTER (check the user manual for a default IP
address - it is usually
192.168. 1 .254 ).
10. Enter user name and password (check the user manual for a default user name and password; it is usually
“
cisco ” for both). Then click Log In.