1. Safety Warning
The Kewtech Fuse Finder 2 is designed for use by suitably qualified
personnel familiar with electrical supply systems.
Before using your Fuse Finder 2 please read these instructions and
safety warnings. Failure to comply with the safety warnings or use of the
unit in a manner not specified by Kewtech may result in serious injury or
damage to equipment.
When testing at light fittings or bare wires, using a fused test lead set
(not included):
If at all possible switch off the power.
Take care not to touch unshielded contacts when using the test lead
adaptor.
Connect RED or BROWN lead to live and BLACK or BLUE lead to
neutral.
Switch the power back on and test.
USE EXTREME CAUTION.
Only use in dry conditions (see specification section).
Always prove that the transmitter and receiver are functioning before use
(see pre-use check).
IMPORTANT: Switch off your mobile phone when using Fuse
Finder as its signal could intefere with the correct operation.
2. Battery installation
The Fuse Finder 2 receiver is powered by a 9V Alkaline battery (not
supplied) type PP3/MN 1604/6F22 or equivalent.
To install a battery remove the screw (take care not to lose it!) and the
battery compartment cover on the rear of the receiver enabling access to
the battery compartment.
Fit the 9V battery observing correct polarity.
Replace the cover and screw.
The transmitter is mains powered and does not require a battery.
When fitted with a new battery and turned on the ‘RCVR ON’ LED will be
solidly lit GREEN.
When the battery power becomes low the ‘RCVR ON’ LED will flash. The
battery will have approximately 20% of its capacity left at this stage and
will shortly require replacement. When in use in this almost discharged
state all of the signal strength LEDs will also flash rather than being
solidly lit as they are with a fresh battery.
www.kewtechcorp.com
www.kewtechcorp.com
Содержание Fuse Finder 2
Страница 1: ...kewtechcorp com Fuse Finder 2 User Manual...
