Kett LE-373, Руководство по эксплуатации

Страница: 28 / 36

28
Step Operation Display Explanation
0
and
numeric keypad
Press the Enter key and check that the thickness (0.0
μm) of the substrate coating is displayed. To change the
thickness of the substrate coating, delete the value with the
Del key, and enter the desired thickness of the substrate
coating from the numeric keypad.
!
Press the Enter key to set the substrate. The display
changes from Standard 0 to Standard 1, so the operation
goes to measurement using a calibration foil.
* If Esc is selected on the display during step
9
or
!
and the Enter
key is pressed, substrate calibration is not set.
@
Measurement of
100μm calibration foil
Place the calibration
foil on the substrate and
perform measurement
4 or 5 times.
Place the calibration foil (the 100
μ
m plastic foil) on the
substrate and perform measurement 4 or 5 times.
*Depending on the material, a measurement value that greatly
differs from that of the calibration foil thickness may be displayed,
but this value will be set to the setting value through steps
#
and
$
, so continue with the operation.
*Calibration using calibration foils should be done in order of
increasing thickness, starting with the thinnest calibration foil.
1
2
5
・・
・・