Kett 94i-II, Руководство по эксплуатации

Страница: 9 / 20

9
1. Attach a Sample
The coefficient of friction between to samples can be measured either by attaching the samples to the slider
with two-sided tape or by fixing the samples in place using the O ring supplied attached to the slider.
● Affixing samples using two-sided tape
Use a piece of two-sided tape pre-cut to a size slightly smaller than the samples to affix
the samples to the slider.
● Affixing samples using the O-ring
Remove the O-ring which is attached to the slider and then wrap the O-ring around the
samples so that they are fixed in place. This method should only be used for thin samples.
* The displayed coefficient of friction is calculated based upon the weight of the slider (30g).
It is therefore necessary to take the weight of the attached samples into consideration.
* When measuring the coefficient of friction between samples, a maximum thickness of
1mm of sample material may be attached.
2. Installing the standard slider or 6-point ball slider (option)
1
Use a slider holder to install the slider as illustrated in the diagram.
2
Install the standard slider or 6 point ball slider in the same way.
● Installing the rubber slider (option)
1
Remove the two bolts which hold the bottom cover in place.
2
Use screws to fix the spacers in place (2 locations).
(Refer to diagram 1.)
3
Install the rubber slider. (Refer to diagram 2.)
Diagram 1 Diagram 2
6. Using the Portable Friction Meter