H
D
E
K
E
1
12.
000
1.0
10.
428
.00
00.
00
40
37240
000
14/15
5.2 Factory settings
The drive unit is reset in the as-delivered condition.
» For step by step instructions, see picture section on page
, point 5.2.
5.3 Push-button sender reset
The push-button sender is reset to the factory settings and can be taught in again.
» Remove battery from housing of push-button sender and insert again with the
button pressed.
» For step by step instructions, see picture section on page
, point 5.3.
6. Operation
» For step by step instructions, see picture section on page
, point 6.
7. System cleaning
7.1 Cleaning the fitting
7.2 Cleaning the front panel
» Open front panel and press rubberised surface of button.
» Close front panel within 3 seconds. The drive unit will now no longer react to
pressing the front for 2 minutes.
» For step by step instructions, see picture section on page
, point 7.2.
NOTE
If several drive units are being used in order to create a continuous front panel, the
new reference run must be carried out or activated simultaneously at all drives
connected in parallel.
NOTE
All saved settings are deleted.
WARNING
Live components
Risk of short circuits and fire due to improper cleaning
» Never clean fitting and drive using liquids, cleaning agents containing
alcohol, solvents or thinners.
» Do not use pressure or steam cleaning devices.
» Disconnect power plug before cleaning.
NOTE
» Only use a duster or vacuum cleaner for dry cleaning.
» Only use a soft, damp cloth for wet cleaning.
NOTE
» The fittings are maintenance-free.
NOTE
» Only use a duster or vacuum cleaner for dry cleaning.
» Only use a soft, damp cloth for wet cleaning.
BA_MA_Free-Kesseböhmer.book Seite 14 Freitag, 12. Juni 2015 9:50 09
