Kesla XS 190, Руководство по эксплуатации и техническому обслуживанию

Страница: 51 / 83

Kesla
®
XS
190
SELF PROPELLED TELESCOPIC PLATFORM
50
4. Fasten an oil filter tool on the filter and turn CCW.
5. Apply a thin coating of new oil to the rubber gasket and turn until the rubber gasket
contacts the adapter. Then tighten additional 1/2 turns.
6.
Reinstall the drain plug and tighten. Turn the draining tube back to the engine room.
7. Open the oil cap and fill oil pan with new oil. Check that the oil level is up the upper
mark of the dipstick.
8.
Close the oil cap and replace the dipstick. Let the engine run as long as the oil
pressure warning light is lit. Check the oil level again. Check for oil leaks.
9.
Reinstall the engine hood sections.
LUBRICATION DIAGRAM
Lubricate the following points every fifty (50) operating hours.
1. Articulation bearings for platform slewing 3 points
2. Bearing surfaces of load control 2 points
3.
Outrigger joints and articulation bearings of cylinders 16 points
4. Articulation bearing of the boom and the turntable 1 points
5. Articulation bearings of the platform, the platform
stabilizer arms and the jib 7 points
6. Articulation bearings of the lifting cylinder 2 points
7. Articulation bearings of the stabilizing cylinders 4 points
8.
Sliding surfaces of the boom and chain sprocket bearings 8+3 points
9. Pivoted axle bearings of wheels 12 points
10. Sliding surfaces of brake cylinders 4 points
11. . Pivot bearing and worm gear: Lubricate every 950 hours or at least every 6 months.
There are two lubrication points in the bearing. The lubrication hoses are located in
the hose grommet under the side hood in the front part of the turntable. Turn the
bearing while greasing. Too much grease can break the gasket of the pivot bearing.
Greasing the worm gear: Drive the boom 90° away from the transport support so that
the work gear is no more at the lower chassis. The worm bear has three greasing
points.