16
Operation of the self-propelled implement
•
By loosening the upper screws and removing the lower screws (Fig.7.2, Pos.2) left and
right on the handrail, it can be fixed in two other positions. The factory setting is the
middle position.
•
If the height adjustment via the handrail is not sufficient, it is still possible to adjust the
guide bar (Fig.7.3, item 1). This is done by loosening and removing four screws (Fig.7.3;
Pos.2). The guide rail is factory mounted in the two lower holes.
7.5 Securing the machine during transport
•
Pay attention to the trailer load of the towing vehicle and the permissible total weight of the trailer!
•
Suitable loading ramps with sufficient load-bearing capacity must be used for loading the machine.
•
The ramps must be secured against slipping.
•
The machine must be secured against rolling during transport. Push the machine all the way forward
until it is on the front side wall with the attachment. The fastening straps wrap around the holder of the
guide rail.
•
If present, engage the parking brake of the drive wheels.
•
Switch off the engine and close the fuel tap.
•
Before unloading the machine make sure that there is no obstacle immediately before the ramps on
the ground, otherwise there is a risk of collision. When unloading several machines, these are far
enough to drive out of the loading zone.
