6
Safety & Operating Manual
Runner Hot Water Pressure Cleaner
FIG. 8
4. The high pressure water jet generates a reaction force in the lance. Keep a firm grip on the
lance handle.
5. Press the trigger on the gun and begin washing.
6. To use the cleaner with hot water, turn the temperature regulator (fig. 7B) to the recommended
washing values.
IMPORTANT
– Your First Start Up
To eliminate any impurities or air bubbles from the water circuit we advise
starting the cleaner for the first time without the lance and letting the water
run out for a few seconds.
Impurities could block the nozzle and cause malfunction (Fig. 8).
STOPPING THE CLEANER
1. Switch off the burner by turning the pressure regulator to position "0" (fig. 7B).
2. Let the cleaner run with cold water only for at least 30 seconds to cool down
the boiler.
3. After using with detergent, flush out the intake circuit. Place the detergent
suction hose (fig. 9) in a tank of clean water and let the pump run for 1 minute
with the dosing tap turned fully on and the lance in detergent delivery
condition.
4. Stop the cleaner by turning the switch to position "0" (fig. 7A).
5. Discharge the pressure from the H.P. hose by pressing the trigger on the gun.
6. Disconnect the water cleaner from the mains electricity supply via the omnipolar switch or by
unplugging the plug from the socket.
7. Turn off the water supply tap (fig. 5A).
USE OF THE DOUBLE LANCE
The double lance allows the operator to select a low or high pressure jet.
The pressure is selected with the gun in position (fig 10)
High pressure:
Position 2.
Low pressure:
Position 3.
NOTE
:
In water cleaners with the “Total Stop” system, the motor starts and stops when the lever on the lance handle is
actioned or released.
