Kernau KIH 7432-2B, Инструкция по использованию и установке, Страница: 33 / 84

33
•
Start up / switch off a heating zone
ACTION CONTROL PANEL DISPLAY
Zone selction Press key [ O ] [ 0 ] and control light
To set (adjust power)
Slide on the “SLIDER” to the right or
to the left
[ 0 ] to [ 9 ]
To stop
Slide to [ 0 ] on the “SLIDER” or
press on [ 0 ]
[ 0 ] or [ H ]
[ 0 ] or [ H ]
If no action is made within 20 seconds the electronics returns to waiting position.
PAN DETECTION
The pan detection ensures a perfect safety. The induction doesn’t work:
•
If there is no pan on the heating zone or if this pan is not adapted to the induction. In this case it is
impossible to increase the power and the display shows [ U ]. This symbol disappears when a pan is
put on the heating zone.
•
If the pan is removed from the heating zone the operation is stopped. The display shows [ U ]. The
symbol [ U ] disappears when the pan is put back to the heating zone. The cooking continues with the
power level set before.
•
After use, switch the heat element off: don’t let the pan detection [ U ] active.
RESIDUAL HEAT INDICATION
After the switching off of a heating zone or the complete stop of the hob, the heating zones are still hot and
indicates [
H ] on the display. The symbol [ H ] disappears when the heating zones may be touched safely. As
long as the residual heat indicators are on, don’t touch the heating zones and don’t put any heat sensitive object
on them. There are risks of burn and fire.
BOOSTER FUNCTION
The "Booster" [P] function allows you to increase the power of the selected hotplate. If this function is
activated, the hotplate operates at the highest power level for 5 minutes. It is intended for quick boiling of a
large amount of water, e.g. for cooking pasta.
ACTION CONTROL PANEL DISPLAY
Zone selection Press key [ 0 ] from the zone [ 0 ] and control light
Start up the „Booster”
Press key [ P ] [ P ]
Stop the „Booster” Slide on the „SLIDER”
Or press key [ P ]
[ P ] to [ 0 ]
[ 9 ]
•
Power management
The total cooking hob is equipped with an overall maximum of Booster power. When the Booster function is
activated, the electronic system automatically regulates all “
Boosters
” selected to equalise the available power
to each element selected for booster. The display is blinking on [ 9 ] for a few seconds and then shows the
maximum of Booster allowed:
HEATING ZONE SELECTED THE OTHER HEATING ZONE
(EXAMPLE: BOOSTER LEVEL 9)
[ P ] is displayed
[ 9 ] goes to a [ 7 ] depending on the type of zone