Kernau KBH 07603 X, Инструкция по эксплуатации

Страница: 28 / 47

28
POWER CONNECTION
The mains voltage should comply with the conditions specified on the rating plate located inside the hood. If
the hood is equipped with plug, it should be placed in a socket that meets the requirements of applicable
regulations and located in easily accessible place. If the hood is not equipped with plug, installation of the
hood entrusts to the qualified technician.
MAINTENANCE AND CLEANING
Before undertaking any operations related to the maintenance of the device, disconnect the hood from the
power supply network. The device should be washed with specialized agents for surfaces made of stainless
steel. The hood should be cleaned with mild agents, do not use abrasives. Regular maintenance will improve
the operation of the hood.
DO NOT USE ALCOHOL!
CAUTION! Failure to comply with the regulations regarding cleaning of the device and replacement of filters
creates the risk of fire. It is therefore recommended to follow the given instructions. The manufacturer is not
responsible for any damage to the engine or fires resulting from non-compliance with the maintenance rules
and the instructions mentioned above.
GREASE FILTER
The hood is equipped with an aluminium filter. The filter is removed by moving the locks in the direction
shown by the arrow (Pic. 5). The filter should be washed by hands as follow: by immersing it in water with a
liquid at a temperature of 40-50
o
C for 15 minutes. After the 15 minutes, start washing and rinse the filter
thoroughly. The filter must be completely dry before placed in the hood again. A filter that is not cleaned
regularly reduces hood efficiency and can cause fire. When washing in the dishwasher, filter may change
colour or discolour, but this does not affect its filtering properties. This filter should be cleaned every 35 hours
of hood operation
.
CARBON FILTER
This hood can be equipped with a carbon filter. This filter is in use when the hood is not connected to the
ventilation duct. The filter should be placed on the turbine as shown on the below picture (Pic. 7). The carbon
filter should be replaced every 6 months.
CAUTION! Do not clean or regenerate the carbon filter.