4
6. Preparation for use
Please refer to diagram 1 on page 3 about the names
of the following items.
6-1 Attaching the Eyepieces
6-1-1 Remove the eyepieces' dust caps.
6-1-2 Insert G10X eyepiece into the eyepiece sleeve.
6-2 Attaching the Objectives
6-2-1 Remove the stage center plate and attach the
objectives to the revolving nosepiece through the hole
on the stage left by the plate.
6-2-2 Attaching the objectives in such a manner that
the magnification increase from low to higher powers
in the clockwise direction.
6-2-3 In the inverted microscope, the front lens of the
objectives faces upward, and is more exposed to
contamination than the objectives of upright
microscopes. Therefore, if there are empty positions
6-3 Attaching the fixator of the universal handwheel
6-3-1 This is an optional part which can be attached
according to your demand.
6-3-2 Joint the fixator to the stage with hexagonal
screws on , and to the connecting-rod of the
6-4 Attaching the Stage
6-4-1 Gently place the stage on the microscope frame by
aligning the stage mounting holes with the threaded
holes on the frame.
6-4-2 Insert the provided Allen screws into the mounting
holes. Tighten the screws using the
provided Allen wrench.
6-4-3 The stage is designed very thin so that the objective
will not hit it when the revolving nosepiece is rotated. Do
not subject the stage centeplage to impact or excessive force, as this may deform it.
6-1
6-2
6-3
6-4
