KERN-DEUDIAM DK 32, Руководство по эксплуатации

Страница: 6 / 20

Manual
03/2015
Check the electrical connections after each use
of the system for damages and address a
professional electrician in case of damages.
Electrical instruments shall be checked by the
professional electrician every year.
If the cable or its extender has been damaged
during operation, don't touch it.
In this case
directly pull the plug from the socket.
The damaged electrical switches shall be
replaced by the professional electrician. The
operation of motors with the damaged switches
is forbidden! The power cable of the motor
shouldn't be used for carrying the motor.
Protect a cable from high temperatures and
sharp edges.
Use only the allowed and especially designated
extenders of cables.
Pay attention that your extender corresponds to
the power of the drilling motor.
Before putting the system into operation,
check the compliance of the voltage with the
socket and the frequency with the data
specified on the table. Tolerances: ± 5% for
voltage and ± 2% for frequency. Qualified
personnel only is authorized to carry out
repair work.
It is especially important to observe
-
the technical operation instructions
- the rules of prevention of injury
- the appropriate use of the tool
-
the use of personal safety gear.
5.3.3 Thermal part
Used diamond crowns can heat up
very
strongly. Therefore use
protective gloves in case a
diamond crown needs to be
changed.
5.4 Requirements to the operator
The drill stand is designed for the
use by a professional operator.
This operator shall get special
permission from the owner of a
drill stand to carry out the operation. Operators
of the machine have to be informed about
possible dangers.
Repair shall be carried out only by specialists of
the KERN-DEUDIAM enterprise or its official
representatives.
Operation while drilling requires big
concentration. If you are overstrained or you are
under the influence of medication or narcotic
substances, operation on drilling is strictly
forbidden. In this case there is a big danger not
only for the operator, but also for the third
parties.
5.5 Means of safety
The operator and the people being in his direct
vicinity are obliged to wear protective glasses,
hearing protection, a helmet, safety shoes and
safety gloves.
6. First steps of operation
6.1 Motor mounting
The motor has to be fixed on a drill stand by
means of a motor plate. It allows to fix the
majority of motors by means of four screws. The
motor plate allows fast fastening of the motor on
a drill stand. For this purpose the motor plate is
set on a carriage.
The drill stand is designed only for electric,
hydraulic and pneumatic motors with a power up
to 3.5 kW.
The scheme of openings for motor
installation
Make sure that the voltage from the socket
corresponds to the voltage specified on the table
of your machine.
Fix the motor and the water collector on a drill
stand, using the lock on the carriage against
return motion. The carriage shall move on a drill
stand freely, but without play.
Set the crown and select the appropriate rotating
speed.
Connect the water supply.
Attention : maximum pressure: 3 bars.