Kermi 6051006, Руководство пользователя

Страница: 5 / 32

5
WARNING
Risk of injury!
Ŷ
Observe the weight of the radiator (see
manufacturer documentation).
Ŷ If it exceeds 25 kg, use a lifting device or
ask other people to help you.
Installation instructions
Ŷ Length (L) 300: Installation not possible,
see figures A to C.
Ŷ
Figures A to C are not possible with angle
Ŷ adapters.
Ŷ
Length (L) 400: Installation possible with
limitations, see figures D to E.Figures D and
E only guaranteed with Kermi Thermostatic
Head ZV0038 0001, ZV0038 0002 and
ZV0038 0003.
Packaging and scope of delivery
Ŷ Check the contents of the support bracket
for completeness and damage (Fig. G).
Designation Quantity
1 Support foot 245 mm 2
2 Holder for support bracket 2
3 Soundproofing clip 4
4 Hook for upright bracket 2
5 Washer 6.4 mm 2
6 Hex nut M6 2
7 Set screw M8 x 8 2
Installation
Ŷ Prepare the required tools.
Ŷ Remove the packaging on the base and rear
of the radiator in the area of the lower lugs
(Fig. 1).
Pre-assembly of the support bracket
Ŷ
Shorten the support feet (1) to the requi-
red length L using the following formula:
L = X-30 mm (starting from L = 245 mm no
shortening necessary) (Fig. 2).
Ŷ
Mount the soundproofing clips (3) in the
recesses provided on the holder (2) (Fig. 3).
Ŷ Slide holder (2) onto the support foot (1)
(Fig. 3).
Ŷ
Screw the set screw (7) (perform two revolu-
tions) into the designated hole in the holder
(2) (Fig. 3).
Installing the support bracket without a
pre-mounted radiator
Ŷ Mark the distances between the holes for
attaching the support bracket (Fig. F, 4–5).
Ŷ
Drill holes and attach suitable dowels
(Fig. 6–7).
ATTENTION!
The fastening materials are intended for
sufficiently stable substrates. However, the
appropriate fastening method must always
be checked on site and the fastening mate-
rials adapted to the structural situation!