Kerkyra Hanse 400e, Руководство пользователя

Страница: 28 / 55

Kerkyra Hanse 400e Yacht Manual
•
STARTING
!
Open hatches and turn blower on (switch to “ON” position) to ventilate
engine compartment. Confirm the following conditions:
#
Audible alarm on
#
Oil pressure light on
#
Alternator light on
#
Coolant temperature light off
#
Water in Seal light off
!
Make sure gear shift is in “NEUTRAL”
!
Set throttle to about 1/3 throttle (push red button and advance the throttle).
!
Turn key to “START” position and release key to “ON” position as soon as
engine starts. Do not return the key to the start position unless the engine
is fully stopped.
!
Confirm the following conditions:
•
Audible alarm off
•
Oil pressure light off
•
Alternator light off
•
Coolant temperature light off
•
Water in Seal light off
•
Water is coming out of the exhaust pipe.
!
If any alarms are showing or cooling water is not flowing, STOP ENGINE
IMMEDIATELY.
!
Place transmission in forward and reverse to confirm operation before
casting off.
!
Monitor engine for 10 minutes before casting off.
•
STOPPING
!
Place gear shift in “NEUTRAL”
!
Allow engine to idle for 5 minutes before stopping.
!
Race the engine before shutdown to clean out carbon deposits (run throttle
from low to high speed and back 5 times)
!
Press and hold “OFF” button and then move key to “OFF” position.
•
FUEL FILLING
!
Fill cap located on aft starboard quarter deck
!
Make sure there is no open flame when filling, including the cabin heater
furnace.
•
PROPELLER: 18 inch 3-blade folding (flex-o-fold).
!
Put engine in reverse to fold propeller while under sail (don’t forget to take
out of gear before starting!).
!
Propeller rotation: Left-hand (CCW in fwd when viewed from astern.)
!
Prop walk: Stern swings to starboard in reverse. Prop walk is minimal
because the saildrive places the prop further forward, provides more clearance
from the hull, and provides a truly horizontal axis of rotation.
BACK TO INDEX