Kerkyra Hanse 400e, Руководство пользователя

Страница: 23 / 55

Kerkyra Hanse 400e Yacht Manual
FURNACE ERROR CODES:
A series of short flashes of the LED on the thermostat control indicates an error condition on
the furnace. The number of long flashes following the short flashes indicates the error code:
F 00 Control module error
F 01 No start (after 2 attempts)
F 02 Flame interruption (>5)
F 03 Under-voltage or Over-voltage
F 04 Premature flame detection
F 05 not used
F 06 Temperature sensor open-circuit or short-circuit
F 07 Fuel pump open-circuit or short-circuit
F 08 Blower moter open-circuit, short-circuit or other defect.
F 09 Pilot light open-circuit or short-circuit
F 10 Overheat – turn off for a few seconds and on again to reset.*
F 11 Temperature limiter open-circuit or short-circuit
F 12 Temperature set-point open-circuit or short-circuit
*This is the most likely error code. If the furnace shuts down with the F10 code, try ensuring
that all the heater outlets are open and unobstructed, and keep the aft head door open at night.
EXTERNAL 12 VOLT SOCKET
There is an external 12 volt socket under the dodger near the electric winch. To
enable the socket a toggle switch located on the starboard cabin ceiling must be
switched on. An adaptor stored in the nav station cabinet can be used to convert this
socket to a standard cigarette-lighter style socket.
BACK TO INDEX