NXT-6RK Proximity Reader and Keypad
Installation Guide
Page 1 of 7
P/N: 01217-001 Rev. A
The Keri NXT-6RK is a keypad reader typically used for card + PIN dual verification applications. It
transmits keypad data in either 8-bit burst (default) or 26-bit Wiegand formats and can be used as a
keypad-only device. Since the NXT-6RK communicates via Wiegand format it requires an NXT-RIM
for operation.
1.0
Specifications
1.1
NXT-Reader Dimensions
•
4.6 inches tall by 3.0 inches wide by 0.7 inches deep
•
11.7 cm by 7.7 cm by 1.8 cm
1.2
Power/Current Requirements
•
10 to 14 VDC @ 115 mA (maximum current draw at 12 VDC)
1.3
Operating Conditions
•
-40°F to 150°F (-40°C to 65°C) – 0% to 90% Relative Humidity, non-condensing
1.4
Read Range
•
w/NXT-C - up to 6 inches (15.2 cm)
•
w/NXT-I/S - up to 4 inches (10.2 cm)
•
w/NXT-K - up to 3 inches (7.6 cm)
Read range is stated in a clean RF and electrical environment using credentials presented parallel to
the reader surface with the reader operating at 12 VDC. Read range may be affected by local
installation conditions. Read range will be reduced when mounted on metal.
•
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which
case the user will be required to correct the interference at his own expense.
•
Changes to this equipment not expressly approved by Keri Systems, Inc. may void FCC certification and the user’s
authority to operate
this equipment.
•
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device.
