KEPCO MST 100-2MHT, Руководство оператора

Страница: 25 / 42

MST-MHT SERIES 071320
2-9
FIGURE 2-4. DC OUTPUT CONNECTOR CONFIGURATION FOR PRELIMINARY CHECKOUT
2.7.3 CHECKOUT PROCEDURE
The following checkout procedure requires commands to be issued by the host computer to the
MST 488-27HT Controller in order to program the power module or read back information (volt-
age, current or status) from the power module; it does not include the IEEE 488 SCPI Bus Com-
mands.
Each module must be assigned a unique GPIB address. The MST 488-27HT controller is the
primary address and the MST-MHT power module is the secondary address. All commands are
sent to this pair of addresses during the checkout procedure.
1. Issue command from the host computer to initialize the Power Module.
*RST
2. Issue commands from the host computer to set the MST-MHT Power Module to Voltage
Mode, program output voltage to +E
MAX
, current limit to I
MAX
and enable the output; e.g. for
MST 36-5MHT, issue the following commands:
VOLT 36,:CURR 5;:OUTP ON
NOTE: The commands used in the following steps use the MST 36-5MHT as an example; sub-
stitute the appropriate values for ± E
MAX
for other models. E
MAX
is the maximum out-
put voltage of the unit listed in Table 1-1; I
MAX
is the maximum output current of the unit
as listed in Table 1-1 for 45 ° C.
3. Verify that VOLTAGE MODE and OUTPUT ENABLED indicators on front panel are on and
VOLTS meter on front panel indicates E
MAX
.
4. With DVM connected across terminals O1+ and O2– of the DC Output connector (Figure 2-
4) verify that DVM reads +E
MAX
(e.g. for MST 36-5MHT DVM reads 36V d-c).
5. Issue command from the host computer to read back voltage.
MEAS:VOLT?
Verify that readback voltage is +E
MAX
(e.g. 36V for MST 36-5MHT).