MST-MHT SERIES 071320
2-5
FIGURE 2-2. CONFIGURATION AND CALIBRATION CONTROLS AND TEST POINTS
2.5.2
INSTALLATION
To install the MST-MHT Power Module in the RA 55H Rack Adapter or CA 400H case, proceed
as follows:
1.
The factory setting for the control bus address is 1; if address 1 is already in use, refer to
PAR. 2.5.1 to change the address setting.
NOTE: If the Power Module is already installed in a Rack Adapter and it is necessary to
change the control bus address, the Power Module must first be removed from the
Rack Adapter as described in PAR. 2.5.3 below.
2.
To ensure full engagement of the module interconnect to the RA 55H Rack Adapter or CA
400H case, pull out the two slotted captive thumb screws (at the front of the Module) and
turn counterclockwise until the threads engage.
Содержание MST 100-2MHT
