3. While holding down the RELEASE button, turn the printer
back on.
4.
Remove your finger from the RELEASE button. The
printer prints the current printer settings and then eject
the paper.
5. Press the RELEASE button to eject the paper completely
and insert new paper to begin the second part of the test.
After the printer prints a pattern, it prints the following message:
***
completed
***
The printer ejects the paper; then enters the normal
mode.
You can change several interface settings by changing the DIP
switch settings. If you need to change any of these settings,
follow the steps below:
1.
Make sure that the printer is off.
1-14 Installation
